Recommended Trailer Breakaway Kit with 1-Amp Charger and 5 Ah Battery  

The Bright Way Push-to-Test Trailer Breakaway Kit w/ 12V, 5-Amp-Hr Battery and 1-Amp Charger - Side Load Item #3802346 needs to be mounted with the words/writing facing out as in the video. It is a side load so the terminals on the battery are at the…

If you are referring to two white wires from the brake magnet that are coming from the rear of each electric brake assembly, then it would not matter which wire is connected to ground and which wire is used for the brake feed. The magnet that…

The Bright Way Push-to-Test Trailer Breakaway Kit #3802346 was designed to attach to the outside of a trailer frame like you asked about so it would work well for you. It is weather proof so that it would do fine as long as you didn't submerge it…

The Bright Way Push-to-Test Trailer Breakaway Kit #3802346 typically requires drilling into the trailer frame in order to install it. Unfortunately, this breakaway system does not have a weld-on trailer frame mounting plate option. For a breakaway…

I recommend our etrailer hubs for your trailer. I've linked the complete selection that fits with your #L44649 bearings. Which ones are exactly the right ones depend on your trailer's wheel size and if it has brakes or EZ lube spindles: Idler…

The front cover of the Bright Way Push-to-Test Trailer Breakaway Kit #3802346 is supposed to swing out like you mentioned. I attached pictures that show the door open. I'd be willing to bet the hinge on the left side of the door isn't fully…

Essentially the two kits are the same thing just under a different brand name with the #50-85-313 being Tekonsha and the #50-85-315 being a Tow Ready. Functionally there is no difference.

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

Yes, you can replace just the Battery #3801250 on your Bright Way Push-to-Test Trailer Breakaway Kit #3802346.

If your 2012 Jeep Wrangler Unlimited came with a 4-Way you will need to use 4 and 7 way installation kit #ETBC7. This is a hardwire installation but it does come with everything you will need for the installation. I have included some links that will…