Trailer Wiring For A 2022 Nissan Frontier  

First of all did this problem just start happening? If the trailer has always worked fine before on the same truck then it's likely a short on the trailer's brake wiring. I would start by cleaning the connector and make sure it's free of…

So you will need to access the 12 pin jumper plug in your Frontier's cab, which as you said is on the passenger’s side behind the kick panel. This is where you will install the harness and relays that activate the trailer tow package, and the…

The first thing to check is the connectors to make sure there is no corrosion present. That can cause a variety of problems. If that checks out you will need to do some other testing. You can sever the blue wire about 4 to 6 inches from the back of…

The first step I suggest for troubleshooting your truck's trailer brake controller is to disconnect the truck and trailer and clean the connectors. If that does not correct the problem, test using a circuit tester like #PTW2992. See the linked…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

Since your 2024 Telluride X-Line is not an LS or S model the correct wiring harness is the Curt #C29ZV. This will plug into the connection points in the rear cargo area and provide you with a 4-way to power your trailer's signal lights. The…

I'm not sure why they include that replacement latch but that is not required for any of the aftermarket hitches or wiring. It is probably something related to the installation of the OEM hitch. The etrailer #e45ZR you referenced is what I would…