Do You Carry a #84 Trailer Spindle That Is Greaseable With a 2" Diameter Stub?  

To remove a hub from an axle, you will need to first remove the grease cap on the end of the hub. This will expose the end of the spindle. Once at this point, you will need to see if you have an EZ-Lube spindle, like #TRU77FR, or a standard…

The #TRU77FR spindle accepts a 3 inch axle beam, and the spindle is designed to be welded into place. If the axle tube is painted on the ends, you'll want to take the tubing down to bare metal so you get the proper penetration on your weld.

Yes, the #84 E-Z Lube Spindle w/ Brake Flange #TRU77FR will fit the 2" schedule 40 pipe.

Since you have a 2-3/8 inch diameter axle and that indicates you have a 3,500 lb axle the 84 spindle like the part #TRU24FR will work great as that is what capacity this axle was designed for. Installing spindles is a precision job that should only…

The #84 E-Z Lube Spindle part #TRU77FR is designed to be used with a 3,500 lb axle tube which have a 3.125" I.D.

The TruRyde #84 Spindle #TRU24FR does have a 2 inch diameter, but that is actually designed to fit inside the 2 3/8 inch axle. The stub on the end will extend inside the axle a little ways allowing for added support

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…