What Trailer Axle Spindle Has Bearings L68149 and L44649  

3500 lb axles have the most common and most consistent spindle sizes. They are typically 1.73 inches at the seal, 1.38 inches at the inner bearing and 1.06 inches at the outer bearing like #TRU24FR. I've attached a video to assist. I've…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

A true 1 inch spindle is a BT8 spindle, like #TRU94FR. The next closest one would be the BTR spindle which is commonly referred to as a 1-1/16 inch spindle, like #TRU44FR and is more common than the BT8. Both of these are typically used with 2,000 lb…

It sounds like you have inner and outer bearings #L68149 and #L44649 respectively. That's a very popular combination on a #84 spindle but the seals are normally 1.719 inches inner diameter. I would verify that number. If this is correct…

As long as the seal in the bearing kit part #BK1-150 is flush with the hub it is okay to have a small gap between the seal and inner bearing. When installing the seal you only insert it enough so that it is flush with the hub. The seal's job is…

The answer to your question will depend on if you have hub centric or lug centric wheels. What's the difference? Lug centric wheels use wheel studs embedded in the hub and lug nuts to attach the wheels. The wheel studs provide all the support for…

If you remove the hub and wipe away the grease on the spindle you can check to see if it is damaged. Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can…

Tire designations ST205/75D14 and ST205/75R14 are both for special trailer tires with a 205mm width, 75-percent aspect ratio and that fit a 14-inch wheel. The difference between them is the tire's type of construction. The ST205/75D14 tire is a…

I'd go on the tighter side of what you mentioned where there's no play yet you can still spin the wheel several times on one push. You might put your hand on the hub to feel if it's getting overly warm next trip you take but I believe…

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

The pilot diameter on a wheel, like the one with part #AM30620, is the diameter of the bigger hole that is directly in the middle of the wheel. The pilot hole diameter of the wheel for the part I just measured is 2.84". I have attached a picture…

Thanks for providing all of the information for your axle. This axle is going to use the standard 3,500 lb axle bearing sizing. You can use the Bearing Kit #BK2-100, which will come with bearings, races, seals, cotter pin and tang washer - everything…