Can Super Titan Pintle Hook Plate part # RP38186 be Used in Rise Position  

The Buyer's Products plate mount hitch, part #33710052, has the standard 1-3/4 by 3-3/8 inch bolt pattern for mounting to a plate. I've linked our selection of mounting plates for you as well.

The Buyers Products 2" Pintle Hook Mount part #337PM90 can be inverted to provide a greater rise or installed in the normal position to provide a greater drop. If you don't already have a pintle hook and hardware you can use the Buyers…

The Gen-Y Torsion Pintle Hook Mounting Plate #325-GH-1301 is currently our only pintle plate which will allow for both a rise or drop with a solid shank. The mounting holes are spread on center 1-3/4" apart vertically and 3-7/16" apart on…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Based on your measurements it matches our Fulton 50-Degree A-Frame Coupler #FE443050303 which looks to be the same as what is on the 2024 Intech Sol Horizon from the videos I could find. So this would use either the EZ Latch #DM14793-81 or…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

The ideal height will actually have to do with how tall the coupler of the trailer is from the ground. The Draw-Tite #76020 will sit at 13 1/2 inches from the ground to the top of the hitch when installed on a 2016 Mazda CX-9. From what I could find…

Yes, it can! To add a 2" hitch ball to the Curt Pintle Hook with 2-5/16" Ball item #C45910-15-20 you'll need the Replacement Hitch Ball for Curt Pintle Hook Combo item #C48820. This is the only way to add a 2" hitch ball you…