Recommended Idler Hubs for Timbren Heavy-Duty Axle-Less Trailer Suspension 3,500 lbs  

If your trailer has separate turn signals from the brake lights and you want them to remain that way, you will need to use a special converter. On the trailer side, behind the 7-Way, you will attach the Vehicle to Vehicle Taillight Converter,…

I spoke to my contact at Curt and they informed me that the reason you are hearing the buzzing noise and the third brake light is flashing when using the Vehicle to Vehicle Tail Light Converter part #C56196 is because the green and yellow output…

I have a solution for you but you'll need to use a different Timbren system. The item #TASR35HDS06 does not have a matching 5 on 5-1/2 lug pattern hub or hub and drum assembly. Instead you will want to use the Timbren Axle-Less Trailer Suspension…

The hubs that fit the Timbren Heavy-Duty Axle-Less Trailer Suspension #TASR35HDS06 use inner bearing #25580, outer bearing #15123, and a grease seal with a 2-1/4" inner diameter. For regular hub use part #AKIHUB-655-6-EZ-K but if you are wanting…

Yes it is possible to add a separate amber directional light to the trailer using part #118158. Most trailers use a 2-wire system. One wire for the running lights on the trailer and the other wire is for the brake/turn signals. You can use the…

The Taillight 2 to 3 Converters like #C56196 do require diodes to be used to prevent feedback. You will be able to solve your feedback issue with a Taillight Diode Kit #48955

The answer actually isn't very technical. Curt doesn't require that diodes be used with the Converter #C56196 however some Experts still like to recommend using a diode like part #RM-690 to prevent backfeed just because you are adding…

Please take a look at the Curt 2 to 3 Wire Tail Light Converter, #C56196. Pair this converter with an isolating diode kit, #38955, to get the signal you are looking for. This is actually designed for use of flat towing a vehicle behind a motorhome,…

Sounds like your trailer has the taillight circuits swapped. Or, you wired the #C56196 backwards. You need to change the stoplight wire of the converter box to the turn signal circuits of the trailer and you'll be set since currently those two…

Yes, you will need to install resistors like the Optronics Load Resistor for LED Lights - Male PL-3 Plug and Pigtail #ALEDRST1B or the Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug #ALEDRST2B. The Curt 2 to 3 Wire Tail…

Yes, I will attach a snip of the installation as well as post it here. 1. Use the double-sided tape on the converter to secure it at the rear of the TOWING vehicle. 2. Connect Yellow Wire (Input) to TOWING vehicle’s Left Turn/Brake Wire. 3. Connect…

The converter box part #C56196 that you referenced would work well for converting a combined taillight circuit to a separate one. Typically this is used on the trailer side of the wiring but there's no reason you couldn't use it on the…