Does Curt SecureLatch Pintle Hook with 2" Ball Have Max Tongue Weight  

I have a solution for you, but the short answer is no, it does not. The Replacement Key for Andersen Hitch Receiver Locks and Locking Adjustment Pins #AM3499-2052 is code specific, so the key will only work on locks with a 2052 code. The codes for…

The Curt SecureLatch Pintle Hook with 2" Ball #CU37FR (48407) requires a hitch ball with a 1-1/4" shank. The collar the shank fits into is 2" tall(see image). We do carry a 2" Replacement Ball #CU67FR as well as a 2-5/16"…

According to the folks at Curt, when the #CU37FR and #C48007 pintle hooks are designed and cast, they are not designed to withstand the force they'd be subjected to if they were inverted and used as standard ball mount. You'd be best served…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…