Where Should Replacement Ramp Door Seal Be Installed On Trailer

Question

Question:

I have a enclosed trailer with a ramp gate. Is it best to apply the weather stripping to the ramp door or to the inside frame encloser? Please advise Thanks

asked by: Bruce K

0

Expert Reply:

The Ramp Gate Seal Kit for Enclosed Trailer Ramp # SR35FR can be installed in either location. Personally, I would keep it off the ramp door since you're more likely to damage it as you walk or move things across the ramp. Inside the frame enclosure would be the way to go.

expert reply by: Robin H

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 6

Hey Scott you will need to get the width of your ramp as well as the weight of the ramp to pick out what you'd need. For example the part #M394FR is for 8 foot wide ramps and has a weight capacity of 185 lb. I attached a link to all of the…

view full answer...

Answer 7

To test the weight of your ramp door, you will want to get the door all the way down to the ground and then on a scale of some kind (a bathroom scale can be used for this if it's the only thing available). This will be when the door is at its…

view full answer...

Answer 8

Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…

view full answer...

Answer 9

I would be happy to! We have quite a few options for TRUE Frame Mounted Torklift camper tie downs for a 2015 Ford F-250. I have listed our entire selection below because there are several different ones depending on what model and accessories your…

view full answer...

Answer 10

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Where Should Replacement Ramp Door Seal Be Installed On Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching