What Ball Mount is Needed For 15 Inch Hitch Height With Draw-Tite Receiver 24872 on 2014 Ford Focus?  

The orientation your Class I Drawbar, part 3593 will depend on the height of the trailer coupler. With the trailer level, measure from the coupler down to the ground. This is the approximate height you'll need the trailer ball to be. You'll…

The ball mount you get to pair with the Curt Trailer Hitch Receiver #C11402 on your 2018 Hyundai Sonata ultimately depends on the height of the trailer coupler that you're towing. A general rule of thumb is that smaller trailers will have a…

Personally I prefer the Curt Trailer Hitch Receiver #C11158 over the Draw-Tite #24872 as the Curt is made in the USA. Both these are Class I receivers with a capacity up to 2,000lbs of trailer weight and 200lbs of tongue weight. Be sure to verify the…

Hi Jordan, Ok, I think I can clear this up for you, and just to get the final answer for you, the maximum COMBINED weight a cargo carrier and its luggage can weigh in your current setup is 175 lbs (also, apologies for the caps but they don't…

You might be able to tow a small 5x8 utility trailer using a hitch ball mounted to the bumper of your truck but this will depend on how heavy the loaded trailer is along with the specific bumper capacity of your vehicle. If you can tell me the year,…

Ball #C48810 is the only 1-7/8 inch diameter ball that also has a 1-1/4 inch shank. Like you said it is made to fit a pintle hitch combo ball mount. What I recommend is a ball with a 1 inch diameter shank like #19260 and then use bushing #58184 or…

I have an answer for you. When it comes to using a hitch adapter on your 1-1/4 inch hitch to accommodate a 2-inch accessory, it is important to note that any time you use an adapter/extender, you will be decreasing the overall weight capacity of the…

According to the installation instructions for the Draw-Tite Trailer Hitch, #24872, you should use a file to enlarge the frame access hole on your 2014 Ford Focus. You will want to enlarge the hole just enough to get the hardware through. I have…

The Curt Trailer Hitch Receiver #C11431 is a confirmed fit for 2013-2018 Ford Focus ST models. It is a confirmed fit for your 2018 model and will fit above the exhaust and under the bumper. This will work well for your bike rack, but you will want to…

I attached a picture that shows the CME-PCL-INS as well as a help article that covers this portion of trailer wiring installs as well. Overall it's not a difficult process but it does take some time routing it up to the front of the vehicle.…