Fastway e2 or Reese Steadi-Flex Weight Distribution Hitch For 8,500 lb Travel Trailer  

The Reese Steadi-Flex Weight Distribution 66561 requires a hitch ball with a 1-1/4" diameter shank. Therefore, for a 2" trailer coupler you will want to use part #A-90 and for a 2-5/16" trailer coupler you will want to use part #19286.…

The Reese Steadi-Flex Weight Distribution System w/ Sway Control - Trunnion - 10K GTW, 1K TW #RP66559 is rated for a total tongue range between 500 and 1,000 lbs. That total tongue weight is the loaded tongue weight of the trailer plus any cargo…

When looking into Weight Distribution (WD) systems you want to find one that has a range that your Total Tongue Weight (TTW) falls in the middle of. Your TTW can be found by adding the Tongue Weight (TW) of your fully loaded and ready-to-go trailer…

A weight distribution hitch is needed if your loaded trailer's weight is more than 50 percent of your vehicle's GVWR. Based off of what you mentioned of a car trailer with a 5,700 lb Jeep, it is very likely going to be more than half of the…

We do carry a lot of different refrigerators however; we do not carry replacement doors. I recommend the Everchill RV Refrigerator Item #324-000119 as a replacement unit if needed.

You'd want to unplug it. There isn't a master on/off switch for the Everchill RV Refrigerator w/ Freezer #324-000119.

Most of the 2-5/16 inch hitch balls will use either a 1-inch diameter shank or 1-1/4 inch diameter shank. The nut size on a hitch ball with a 1-1/4 inch shank, like the Tow Ready 2-5/16 Inch Hitch Ball, part #19286, will use a 1-7/8 inch socket. A…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…