bing tracking image
Q & A Icon

Will Sportframe Drawbar # 3594 Fit Kubata RTV Receiver

Question:

I want to use this on our RTV Kubota. to get the pin in, It only can go two inches deep before it butts up against the axel. Can this unit work?

0

Expert Reply:

I pulled a Sportframe Drawbar, part # 3594, from our warehouse and took a measurement for you. As the attached photo shows the distance from the end of the shank that inserts in the receiver on your Kubata RTV to the center of the hitch pin hole is 1-1/2 inches. This drawbar is designed to fit 1-1/4 inch receivers.

You mentioned that you have 2 inches before it hits the axle. The best way to see if this will work is to take a ruler and insert it in the receiver on your RTV. If you have more than 1-1/2 inches inside the receiver on your RTV from the center of the hitch pin hole to where it stops, or bottoms out, this would work for you.

click to enlarge
expert reply by:
0
Jeffrey L

Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>