Can Block be Used Under etrailer Tongue Weight Scale  

You will want the trailer to be on level ground and level (parallel) with the level ground to use the etrailer Tongue Weight Scale for Campers and Utility Trailers #e99044. You may have to go to an empty parking lot or a different street to get more…

You can use the etrailer Tongue Weight Scale #e99044 in two different configurations; either by connecting it to your trailer coupler, or by removing the foot on your jack (if it has a 2" diameter inner tube). What you'll want to do is load…

I attached a link to the install instructions for the etrailer scale part #e99044 which the last line covers storage, "Store the etrailer tongue weight scale in a secure place when not in use." There is no additional storage steps needed…

The etrailer Tongue Weight Scale for Campers and Utility Trailers #e99044 like many scales use hydraulic oil which can be stored at 32F to 77F. So you wanting to store this in your trailer which gets down to -5F is a bit too cold for this. Ideally…

I have a few options for you to replace the Bargman 30-91-010 Tail Lights. There isn't a direct LED replacement. The Bargman Trailer Tail Light part #30-92-001 and part #30-92-003 are direct replacements but they are incandescent. You could…

The closest LED tail light we carry to Bargman #30-92-002 that you referenced is part #328-003-81M1 for the passenger's side and #328-003-81LM1 for the driver's side. They're fairly close in size but don't have the reverse light…

I would run a set of e-tracks down the length of the floor of your trailer like part #E19148 (5 foot section), and then use the wheel nets like part #EM58523 to secure the wheels of your cars to the tracks. Check out the install videos I attached as…

Yes, you just have to remove the old lights, match the wires and mount the new ones. Please note, that it is usually not a good idea to mix LEDs and incandescent lights, so if you have have side markers or other lights on the trailer, make sure you…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…