What Color Wires Circuits are On Optronics LED Light # STL90RB
Question:
Hello on this STL90RP so it has the three wires. White is ground. Do you hook the signal wire up with the running light wire? I loved this video but would like to see how to hook 4 wires to the 3 wires.
asked by: Troy R
0
Expert Reply:
On the Optronics light # STL90RB the black wire is for the stop/turn circuit so that is where you'd run your blinker circuit to. The black wire gets the running light circuit and white is ground.
You would need to identify all 4 of your wires to determine how to run them to the light. It's very possible that two of the wires are grounds.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Transit Tail Light - Stop, Tail, Turn - Submersible - 31 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Surface Mount
- Submersible Lights
- LED Light
- 7 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Shop: Optronics LED Transit Tail Light - Stop, Tail, Turn - Submersible - 31 Diodes - Red Lens
- Q&A: Light To Replace Older Reflecto Light 110-150 On Travel Trailer
- Q&A: Replacement Baby Moon Hub Cap For Vintage Boler Trailer
- Q&A: Difference Between 7-Way Round and 7-Way Blade Connectors
- Q&A: Is Time Delay Feature on Go Power Transfer TS-30 Switch 34264403 Manual or Automatic
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Motorhome Steps
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Replacement for Dexter Hub 008-249-07 and Replacement Electric Brakes
- Q&A: Reverse Light PIn on a 7-Way Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements