Replacement Fender for a 2022 Arising Industries Cargo Trailer

Question

Question:

I have a 2022 ARising Ind. cargo trailer, the tires are 26" I’m looking for a wheel fender for it, Do you carry this and if so how much? Thank you

asked by: Tammy

0

Expert Reply:

To replace the fender on your 2022 Arising Ind. cargo trailer I recommend the following:

- CE Smith Single Axle Trailer Fender # CE17100ATB

To install this on your trailer you'll need mounting brackets light part # CE26098G-2 as well as mounting hardware you can find at your local hardware or home improvement store to match the material of your trailer.

expert reply by: Jon G

0

Fender on a 2022 ARising Ind. Cargo Trailer
(click to enlarge)

Fender Location on a 2022 ARising Ind. Cargo Trailer
(click to enlarge)

Answer 1

Trailer fenders are classified by the diameter of the trailer wheels they're compatible with. For instance, the #F008583 fender you referenced works with 13 inch diameter wheels. If you're unsure of the diameter of your wheels, the last two…

view full answer...

Answer 2

The CE Smith Single Axle Trailer Fender part #CE17100ATB that you referenced has a radiused lip on both sides of the fender. It can still be bolted on though as the fender lip does go flat. It will set flush to the side of your trailer, but the round…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 10

Hey Dan, The info you provided does tell us a bit about the axle but isn't enough to look up what components go with with it. With it being a 3,500lb axle it's probably a generic 3,500lb kit for the bearings and seals but I'd hate to not…

view full answer...

Answer 11

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 12

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

view full answer...

Replacement Fender for a 2022 Arising Industries Cargo Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching