Replacement Spindle Washer For Dexter 2,000LB Trailer Axle
Question:
While removing the Dexter 8-259 hubs i noticed there were no washers on either side of the axle. The trailer has a 2000lbs.capacity and built in 2008.My question is do the hubs require washers.Thank-you
asked by: Dave
1
Helpful Expert Reply:
Products Referenced in This Question
Product Page this Question was Asked From
Similar Expert Q&A Pages
- Replacement Bearing Kit, Spindle Washer, & Nut For 5,200 lb Lippert Trailer Axle
- Availability of Spindle Washer for Boat Trailer
- Spindle Washer Compatibility With 1 Inch Spindle Without D-Shape
- Correct Replacement Spindle Washer for Dexter 3,500LB Axle
- Diameter of Spindle Washer # SW1000 and Wobble Roller Retainer Ring CE10981
- Outside Diameter of the Washer SW1000
- Does Trailer Hub Without Spindle Washer Need to Have One Installed
- Where to Measure to Pick Out Replacement Spindle Washer
- Washer and Castle nut for 1 Inch BT8 Spindle
- Spindle Washer to Fit 1 Inch Diameter Spindle
- Where Does Flat Washer Go
- How To Fix the Cotter Pin Not Catching the Ears On Spindle Nut For a Boat Trailer
- Is Spindle Washer Needed On Reliable Torsion Axle?
- Replacement Spindle Washers For An Old Trailer With 10k Axles
- Wobbler Rollers With 1-1/2" Long Bushing For 1" Shaft EZ Loader Magic Tilt Trailer
- Replacement for Missing Spindle Washer Used with Bearing Kit BK1-150 and Castle Nut
- Washer For 1 Inch Spindle Bearing Kit BK1-100
- Spindle Washer for Use with Trailer Hub # 8-201-9UC3-EZ
- Replacement Hub Components For Drift Boat Trailer With BTR Spindle
- Should There Be a Washer Between Outer Bearing and Castle Nut on etrailer 2,000 lb Trailer Axle
- How to Determine Which Spindle Washer To Use With DL21792 Bearing Kit
- Do I Need a Washer with Castle Nut to Install Dexter Trailer Idler Hub Assembly for 2,000-lb Axles
- Washers for BT8 Trailer Axle Spindle
- Replacement Galvanized Trailer Idler Hub For a Continental EC39 Boat Trailer
- Correct Replacement Castle Nut, Cotter Pin, and Washer for Trailer with 1" Round Spindle
- How To Use Bearing Kit for #84 Spindle with Round Spindle
- Replacing A Castle Nut On An Axle Rated For 2,500 Lbs