Replacing The Zerk Fitting On A Dexter EZ-Lube Trailer Axle
Question:
what size is the Zerk on the end of a trailer spindle? I had to remove it to use a puller to get a bearing off and misplaced it .
asked by: Christopher B
0
Expert Reply:
The zerk fittings on the Dexter Trailer Axle # T3584F-EZ-8974 are a 1/4" pipe thread. If you need a replacement zerk fitting you can use part # Gzerk, which we have confirmed to fit the Dexter Ez-Lube Axles.
expert reply by:
Jesse M
0
Products Referenced in This Question
Replacement Grease Zerk for Ram Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Grease Zerk
- etrailer
more information >
Product Page this Question was Asked From
Dexter Trailer Axle Beam with EZ-Lube Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- EZ Lube Spindles
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Spring Center
- 89 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Continue Researching
- Shop: Hydraulic Trailer Brake Kit - Uni-Servo - 12" - Left and Right Hand Assemblies - 5.2K to 7K
- Search Results: caps trailer bearings races seals caps
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Video: What to Know About the Demco Hydraulic Brake Actuator-DM72VR
- Video: All About the Demco Hydraulic Brake Actuator-DM72VR
- Search Results: gs~2125dl
- Shop: Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Search Results: race
- Shop: 10-10 Grease or Oil Double-Lip Seals - Qty 2
- Shop: Replacement Race for 15123 Bearing
- Shop: Replacement Master Cylinder Assembly for Dexter Model 60 and Aero 7500 Brake Actuators - Drum
- Shop: Replacement Master Cylinder for Dexter Aero 7500 Brake Actuators - Disc
- Shop: Dexter Zinc-Plated Brake Actuator - Disc - Multi-Fit Ball - Bolt On - 7,000 lbs
- Search Results: free backing brakes
- Search Results: 10~10
- Search Results: 10~36
- Search Results: lm67010
- Video: All About the Master Lock Pivot Lock Hitch Pin for 2" Hitches
- Video: Feature Breakdown: Seal Puller
- Video: All You Need to Know About the Grease Cap, 1.99" OD EZ Lube Drive in with Plug
- Q&A: How To Fix/Replace Grease Zerk Fitting on a Dexter EZ-Lub Axle
- Q&A: Retaining Nut For Dexter Hub & Drum 5,200 lb - 6,000 lb Part 8-201-9UC3-EZ
- Q&A: Solution for Zerk Fitting of EZ Lube Spindle Wearing Out Rubber Cover
- Q&A: Are E-Z Lube Grease Zerks Threaded or Pressed In
- Q&A: Is it Normal For Trailer Axle to Not have Grease Fitting
- Q&A: Options For RV Slide-Out Tray Assemblies