Tools Needed to Install Enclosed Trailer Transition Plate

Question

Question:

what tools are needed to install this transition plate?

asked by: Jack

0

Expert Reply:

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate # e32JR:

- Tape Measure
- Drill
- Hex Drive Socket Adapter
- 10mm Socket
- 13mm Socket

I have also added a link below to the instructions of the # e32JR for you to take a look at.

expert reply by: Kyle S

0

Answer 1

In regards to the etrailer Enclosed Trailer Transition Plate #e32JR, the end plates are not designed to be swapped. There are pre-drilled holes in the end plates and center plates, which would not line up correctly if the end plates were swapped.…

view full answer...

Answer 2

The etrailer Enclosed Trailer Transition Plate #e32JR will work very well for loading and unloading motorcycles. It has a working load limit of 1,000 lbs so even with your 850 lb bike, you are well within parameters weight capacity wise. Especially…

view full answer...

Answer 3

Yes, you can cut the hinge, #H300, to the size you need with the proper equipment. An angle grinder with a cutting wheel would be a good choice to cut the hinge. We have other hinge options if you are interested. I have linked them for you.

view full answer...

Answer 4

The etrailer Enclosed Trailer Transition Plate #e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when loading…

view full answer...

Answer 5

Greetings Tim; when you choose a WDH you want to go off of the tongue weight of your loaded setup. The best way to find this is to measure with a scale like the #BTBRV44FR. Since you provided the specs for your trailer we can take a guess to help…

view full answer...

Answer 6

Hey Linda, The listed length of your pop-up is showing as 17' so the body is likely more in the 14' to 15' range, but you'll want to measure the body of the trailer like the diagram below to confirm. If the trailer body is 14' to…

view full answer...

Answer 7

Hey Kevin, I took some overall measurements on the Replacement Power Unit for etrailer and Ram Hydraulic Trailer Jacks and Scissor Hoist Systems #e43VV and drew up a little diagram below. If you need any other specific measurements just let me know…

view full answer...

Answer 8

Hey Mark, The 30 amp Portable Power Watchdog Surge Protector with Bluetooth, Wi-Fi, and Emergency Shut Down #HU42VR weighs 6 lbs and measures 19" including the cord, with the body measuring 12" tall; it is also 6.5" at its widest point…

view full answer...

Answer 9

Hi Mike; to find the right weight distribution hitch for your 2023 Jayco Jay Flight 240RBS you will need to know the tongue weight of your loaded setup. The best way to find this is with a tongue weight scale like the #BTBRV44FR. You can also use one…

view full answer...

Tools Needed to Install Enclosed Trailer Transition Plate

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching