Replacement Module for Lippert Ground Control 694656

Question

Question:

I need to replace my Lippert Ground Control 3.0 control module electric leveling system. I want to verify that this part on your website LC304136 is the correct replacement part. The numbers on the control module are different on my control module than on what you show. My Controller in blue numbers 694656 and under it 22285 it is for a 4 point system

asked by: Gena S

1

Helpful Expert Reply:

We have checked in the past with Lippert and the correct replacement module for the 694656 that you have is the part # LC304136.

expert reply by: Jameson C

1

Answer 1

If you aren't getting any error codes on your controller then I recommend first checking the power to each motor of your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC358590. If you have a full 12v at each motor then we have…

view full answer...

Answer 2

When your Lippert Ground Control 3.0 #LC358590 has a reading that says "Comm Error" it is referring to the communication between the controller and touch pad. You will need to check your harness to ensure it is connected properly and there…

view full answer...

Answer 3

You are looking for the Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System #LC304136 to disconnect the system from the battery. This control module is normally located inside a compartment toward the front of the…

view full answer...

Answer 4

The LR jack code means your left rear jack leg is not able to be controlled by the computer of the Ground Control 3.0 basically. This can be a hall signal issue (open ground/short, or other malfunction) or an unexpected high amperage current stall…

view full answer...

Answer 5

If you are absolutely sure your battery is in great shape and all of the wiring is good the module would be at fault and it would be time to replace it with the part #LC304136 that you referenced.

view full answer...

Answer 6

The correct replacement module for the 694654 that you have now is the part #LC85ED.

view full answer...

Answer 7

If you have the Ground Control 3.0, you need the Replacement Control Module part #LC304136 for 4-Point or part #LC85ED for 6-Point. If you need the control panel, that's the Replacement Control Panel for Lippert Ground Control 3.0 and Travel…

view full answer...

Answer 8

There is only one option to replace a Lippert, which is now Curt, Turning Point. You will want the Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box item #GY48GR. As far as make and model goes. 5th wheel trailer pin boxes are not model…

view full answer...

Answer 9

It actually is just that, an antenna. I spoke with my contact at Lippert who said that some models of the Lippert Ground Control 3.0 #LC358590 are wireless. The antenna on the Control Module #LC304136 is there for those systems.

view full answer...

Answer 10

I reached out to my tech contact at Lippert and they said you have replaced 2 of the 3 communicating pieces on your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC358590, so you've isolated the issue. The part you now need is…

view full answer...

Answer 11

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

view full answer...

Answer 12

Thank you for providing those pictures, using the pictures I was able to determine that the Replacement Touch Screen Control Panel #LC83VR is the correct replacement for your Lippert jack system.

view full answer...

Replacement Module for Lippert Ground Control 694656

Product Page this Question was Asked From

Continue Researching