How to Determine if the Grease Cap for a Hub

Question:

I have a grease cap with TRP on the outside top and an H on the bottom. What would be the replacement cap for this model.

asked by: Bubba H

Expert Reply:

If you are looking for a grease cap PLUG with the TRP stamped on it chances are the Grease Cap Plug for E-Z Lube Grease Caps # RG04-010 would work for you, but to be certain you will want to measure the diameter of the grease cap hole. If it is 1.18 inches across then the # RG04-010 would work for you.

If you only needed one cap you would want the # DC-RP.

If you are looking for the whole cap you would need to check out the picture I attached that shows where exactly to measure to determine what cap would be needed. It is important that you use a precise measuring tool such as a dial caliper to take this measurement.

I attached a page that has all of the grease caps we carry. You will need to select the distance you measured earlier from the outer diameter facet and the correct caps will be listed.

expert reply by: Jameson C