Question:
I have a hitch, but need a few more inches of drop. On the RP3344 what is the distance from top to last hole on unit? I was following your example, but need to recheck trucks receiver height, its around 25.5inch and the bottom of coupler is 19. Thanks
asked by: Perry G
Helpful Expert Reply:
Based on the dimensions you gave for your truck's hitch height and the height of the bottom of the coupler of your trailer you need about a drop of 6-1/2 inches.
The Reese Shank part # RP3344 that you referenced has a maximum drop of 6-3/8 inches when used in the lowest position with a round bar setup or 6-1/8 when used with a trunnion system. That would be almost exactly the drop you would need so this shank would work very well for you and will allow you to tow your trailer level.
I attached an FAQ on determine the correct rise/drop ball mounts for you to check out.
Video/Article/FAQ this Question was Asked From
Article or Video
