Will the Curt Replacement OEM USCAR Trailer Connector Fit in the Same Spot as the Factory 7-Way?

Question

Question:

Will this 7 way and 4 way fit into the factory steel mount the same as factory on my 2005 GMC Yukon XL Denali ? Doesnt make much sense to have to drill for another mount to put along side this one.

asked by: Charlie

0

Expert Reply:

Thanks for the picture! Yes, it will. The old factory connector on your 2005 GMC Yukon XL Denali will pop out once you disconnect the wiring harness and you'll be able to insert the Curt Replacement OEM USCAR Trailer Connector item # C42JR.

expert reply by: Jerred H

0

2005 GMC Yukon XL Denali
(click to enlarge)

Answer 1

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 2

Because vehicle wire color coding can vary, even within the same model year, we always recommend wiring by function, not by wire color. At the vehicle assembly plant, if they run out of a particular color of wire, they will not shut down the assembly…

view full answer...

Answer 3

The Hopkins 7-way part #HM11141144 that you referenced normally fits a bracket like the part #HM40978 which I attached a picture that shows all of the dimensions of.

view full answer...

Answer 4

The 4-way install harness part #C56020 that you referenced is a confirmed fit for your 2005 Ford E-150 van and would be one component needed to install your Curt Echo part #C79DR. You would also need the part #C26DR with 10 gauge wire part #10-1-1…

view full answer...

Answer 5

Hi Scott, The Curt Replacement OEM USCAR Trailer Connector #C42JR does not support both the 4-way and 7-way at the same time so you would need to switch to the Hopkins #30955 if you have a USCAR style connector or the Hopkins #HM48470 if you…

view full answer...

Answer 6

There are a couple of differences between the wiring harnesses for your 2016 Ram ProMaster. The biggest difference is the technology used. The Curt #C56270 uses what is called Surface-Mount Technology. Essentially what this does is almost eliminate…

view full answer...

Answer 7

I attached a picture that I took from the install video you referenced (also attached), that shows where the rubber grommet will be located in the compartment of your 2011 Toyota RAV4. It's hard to see in the video, but its at the very bottom of…

view full answer...

Answer 8

Hey Bill, the Curt 7-way part #C42JR does fit your 2017 Audi Q7. The Audi part number you referenced is a standard 7-way like what this part number was designed to replace.

view full answer...

Answer 9

Thanks for the picture. In the picture of the vehicle end connector it is showing that the center pin has fallen out and will need to be replaced. For a replacement you will need either the Pollak Black Plastic, 7-Pole, RV Blade-Style Trailer Socket…

view full answer...

Answer 10

Sounds like your 2017 Audi Q7 has the round connector needed for installing a 7-way like the part #A10-7072VP that you referenced. All you'd need to do is plug this in and you'd be set. I attached a picture that shows the round connector your…

view full answer...

Will the Curt Replacement OEM USCAR Trailer Connector Fit in the Same Spot as the Factory 7-Way?

Product Page this Question was Asked From

Continue Researching