Do You Cut Tabs on Both Stacked SeeLevel Sensors SE88VR

Question

Question:

SEELEVEL SENSORS 710-AR When stacking the sensors do you have to cut the tab on both sensors or just one?

asked by: Jacob

0

Expert Reply:

Per SeeLevel, for a stacked configuration of the SeeLeveL Sensor for RV Holding Tank Monitor - 9" Long # SE88VR you just cut the top sensor.

expert reply by: Kyle S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Yes, we do! To add a hitch to your 2024 Ford Edge, I recommend the etrailer item #e36RR. This hitch is custom fit and bolts to your Ford with included hardware. This hitch fits all models of the 2024 Edge including the Titanium, SEL, and SE. I really…

view full answer...

Answer 4

You do not need to remove the exhaust heat shield on your 2021 Ford Edge to install the Curt Trailer Hitch #C13234 you were looking at. With that said you will need so cut a section of the underbody trim panel so that the hitch will fit correctly,…

view full answer...

Answer 5

Hey Ed, The SeeLevel Tank Monitor 709-P3 can be purchased under part #SE44VR and the 710-AR sensors can be purchased with part #SE88VR. These are all sold individually so you would need to get three of the #SE88VR to have one for each of your water…

view full answer...

Answer 6

I spoke with my contact at SMI and the piece you are looking for is #SM99625 which is the fitting and the bracket. Or if the bracket is still fine and all you need is the fitting you just need the part #SM99726.

view full answer...

Answer 7

We don't sell High Pointe parts and I wouldn't know where to get replacements but we do have an option for a replacement rack: - Replacement Round Cooking Rack for Hisense Over-the-Range Microwave #324-000151 This rack measures 11-15/16"…

view full answer...

Answer 8

Hey Scott, No that's incorrect, you will need an adapter for both the Roadmaster Nighthawk #RM-676 and Sterling #RM-576 tow bars for use with etrailer Invisible Base Plates. So for both tow bars you would need the Roadmaster Sterling and…

view full answer...

Answer 9

Hey Teresa, The trim kit for the High Pointe Built-In Convection Microwave with Air Fryer #HP36ZR is approximately 24" wide by 17" tall.

view full answer...

Answer 10

You are going to need a different monitoring panel for the SeeLeveL sensors since your current probe style sensors like the #T21301VP are only going to show open and close readings since each tank will have multiple sensors. You will want to use the…

view full answer...

Answer 11

We have the 710-AR and 710-ES2 SeeLevel sensors, though I was unable to find any 701AR or 701ES2. If you were referring to the 710-AR and 710-ES2 you would need the following: - 710-AR: SeeLeveL Sensor #SE88VR - 710-ES2: SeeLeveL Sensor #SE78VR

view full answer...

Do You Cut Tabs on Both Stacked SeeLevel Sensors SE88VR

Product Page this Question was Asked From

Continue Researching