What 3" Wide, 6' Long Hinge Has a 3/16" Thick Side Plate?

Question

Question:

I was needing to know the thickness of the plate on both sides of the barrel. It looks to be about 1/8”, but was needing to know for sure before I order. I need it to be at least 3/16”

asked by: Tanner B

0

Expert Reply:

The side plates on the 3" Wide Continuous Hinge # MA65VR you found are 0.09" thick which is just under 3/32". We do have a 3" Wide # MA52VR which is 6' Long with a 1/2" pin that has 0.18" thick side plates which is slightly thicker than 3/16" thick.

expert reply by: Bud M

0

Answer 1

Marlboro does not list weight capacities for either the #MA75VR or the #MA45VR that you referenced. They state it will be up to the installer to determine the appropriate weight capacity. We also do not have this in a 3 foot length.

view full answer...

Answer 2

The Replacement Hinge Pin #362TRCHingePin2 is 0.12" in diameter.

view full answer...

Answer 3

We only have one piano hinge that is either 4" or 6" wide and constructed of either stainless steel or aluminum. That is the 4" Wide Continuous Hinge #MA38JR which is made of aluminum and 72" long with a 3/8" pin diameter. We…

view full answer...

Answer 4

For a set of ramp hinges with a grease fitting the part #PLR1902 would work well for you. Overall the hinge measures 8-3/16 inches long, the end pieces are 1 inch in diameter, and the plate portion measures 4 inches wide by 2-5/8 inches deep. I…

view full answer...

Answer 5

Unfortunately we don't have a repair kit at this time. If you choose to replace the entire coupler, I recommend the Bulldog Collar-Lok Coupler w/ Low-Profile Latch - 2-5/16" Ball - A-Frame - 12,500 lbs #BD028499. For a bolt on option, you…

view full answer...

Answer 6

The 4-bolt brake mounting pattern is fairly rare in a 12 x 2 inch assembly. We have some options though; for 6K axles we have #23-105-09 for the left and #23-106-09 for the right. The 4-bolt pattern on these assemblies is offset meaning the bottom 2…

view full answer...

Answer 7

The four bolt brake mounting flange for 8,000 lb trailer axles is going to be more or less an industry standard. This industry standard is 3-5/8" across left to right on center and 3-7/16" top to bottom on center. This could very well vary…

view full answer...

Answer 8

The side plates on the 3" Wide Continuous Hinge #MA65VR you found are 0.09" thick which is just under 3/32". We do have a 3" Wide #MA52VR which is 6' Long with a 1/2" pin that has 0.18" thick side plates which is…

view full answer...

What 3" Wide, 6' Long Hinge Has a 3/16" Thick Side Plate?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching