Replacement Waste Valves For A 2014 Winnebago Journey

Question

Question:

Hello, 2014 Winnebago Journey I would like to replace my Valterra dump valve. There are two couplers and two rubber hoses with clamps. The 3 hubs plus lug cap seem to be the right ones. The T84 and the T85 both seem correct. Which one is right? and do you carry the hub size 3 inch rubber coupler?

asked by: Greg J

0

Expert Reply:

Hi Greg,

Without seeing the setup it's a bit hard to say exactly what is going to be the correct fit for your motorhome. If you want to take a few pictures at different angles so I can see how your system is ran I'd be happy to help find the correct fit. Are you just needing to replace the gate valves # T1003VP or does the whole assembly need to be replaced?

The # T84 has hubs on each side to slip over 3" straight pipe and comes with lugs and a bayonet cap, making it complete. The # T85 also has hubs but comes with a spigot-style outlet that would require another fitting, like # T1029-2, in order to connect your waste hose.

expert reply by: Kevin C

0

Answer 1

We do carry a replacement access hatch, #A10-2171VP,which is 5 inches in diameter, and numerous electrical cable hatches that may work, depending on the size you need. I've linked the page with each of the hatches for you to take a look at.

view full answer...

Answer 2

Thanks for the clarification, yes, the EZ Coupler 4-in-1 Threaded RV Sewer Adapter #F02-3112CL and Valterra Gray Water Drain Adapter #T1020-5VP will be compatible with each other and allow you easily, and cleanly, dump from your macerator to the…

view full answer...

Answer 3

You should be able to tell which Valterra Double RV Waste Valves you need by inspecting your current connection points. The one end with the lugs on it is the same on all 3 parts so you simply need to determine if you need hubs, spigots, or a…

view full answer...

Answer 4

Thanks for the photo and based on that we do have a replacement that will work for you although you are going to need to know what your gray water pipe and black water pipe connections are - either spigot or hub - which I'll explain but you are…

view full answer...

Answer 5

The Progressive Dynamics RV Power Control Center #PD4135K is going to be the closest in dimensions to replacing the Magnetek model 80 power center you have. This control center fits inside a 10-1/4" long x 7" tall cutout and is 11-1/4"…

view full answer...

Answer 6

I believe I understand what you are asking and while the handle of the Valterra Waste Valve Bodies w/ Flexible Cables for RV Black Water and Gray Water Tanks - 72" #TC1372 can be pointed down, and it is capable of a 90 degree angle, the cable…

view full answer...

Answer 7

Typically it's not going to matter since the bolts are just used to hold the valve body together, so the bolts holding your current waste valve together won't matter. If you waned to use the LaSalle Bristol Cable-Actuated RV Waste Valve for…

view full answer...

Answer 8

I don't know the length of the cable used for valves on your Montana so you'll want to measure the length to determine the correct replacement. To make the swap out easy I recommend just unbolting the old valve from the system and then swap…

view full answer...

Answer 9

This is a super common question so you're not alone in not knowing the difference in the connection types. A "SPIGOT" is a piece that will slide into another fitting such as the "HUB". If you look at the picture of the elbow…

view full answer...

Replacement Waste Valves For A 2014 Winnebago Journey

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching