Troubleshooting Curt Echo Brake Controller Where Brakes go To Max Setting Immediately
Question:
I have a Curt Echo brake controller, been using it weekly to pull a camper for about 6 months now without any issue. Today, however, when I press ANY amount of brake via the pedal the apps ring that indicates how much brake is being applied, goes MAX, when it used to only light up maybe half way. If I press the button on the app manually it operates normally not max brake I have adjusted the max output down a bunch to make it not lock my brakes up, but the ring is still showing MAX every time the brake is applied. Have rebooted phone, powered the CURT down and back up by unplugging it and plugging it back in and reconnecting. What can I do to fix this as its undriveable at low speeds and dangerous at high speeds.
asked by: Ryan
Expert Reply:
Hey Ryan, so usually when this problem occurs it's because one of the stop/turn circuits is shorting out to the brake output circuit which then causes the brakes to get full 12 volts anytime the stoplights would get activated normally. An easy way to test this is to put on the blinkers to see if the brakes pulse with one of them. Usually this is a short in wiring between the two circuits that causes this from cut or exposed wiring so inspecting those two circuits and fixing as needed would take care of that.
If that is not problem the controller is bad based on that and what you've already tried.
Product Page this Question was Asked From
Curt Echo Wireless Brake Controller - 7-Way Plug Mount w/ Bluetooth App - 1 to 2 Axle - Proportional
- Trailer Brake Controller
- Proportional Controller
- Hidden
- Up to 2 Axles
- Smartphone Display
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Does HBA-CAM Adapter Module for Hydrastar Electric Over Hydraulic Brake Actuators have 2 or 4 Wires
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Curt Echo Full Review
- Q&A: How To Setup a 2019 Jeep Cherokee Trailhawk for Flat-Towing
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome