Will Curt Crosswing Fifth Wheel Hitch fit in B and W Above Bed Rails  

It is normal for the Skid Pads #C38FV to move around between the plates on the Curt CrossWing #C92DR. The notches is the plate prevent the pads from falling out and help to allow the hitch to move around inside the bed and quiet noise. Do note that…

The nylon bushing is not meant to be re-used. I would encourage you to do a height test before tightening it down all the way. 300 ft lbs is a lot of torque. The Crosswing #C92DR is designed to be dedicated to a single trailer. So the idea is that…

If you have the Gooseneck versions of the Curt CrossWing ( #C92DR or #C32DR) you unfortunately would not be able to use the Rota-Flex with it. The pivoting head causing too much strain for the single point of contact you have with a gooseneck hitch.…

First you will want to install a set of 5th wheel rails using the Curt Custom Fifth Wheel Installation Kit #C16443-204 on your 1999 Ford F-250 Super Duty 4wd. This kit includes custom mounting brackets which greatly reduces any drilling required on…

The Demco Recon #DM8550043 and Curt CrossWing #C86JR have quite a few differences that separate the two similar designs. The Recon has an extra 1,000lbs of capacity and comes with a 15-1/2", 17-1/4", or 18" height setting. The…

All the MORryde Cushioned 5th Wheel Pin Boxes #MR57VR, #MR37VR and #MR97VR will share the same dimensions and are nearly identical to the Lippert 1716 5th Wheel Pin Box #LC1324791. I have attached a technical drawing for the MORryde pin boxes similar…

If you are wanting something light weight then the Curt CrossWing Lightweight 5th Wheel Trailer Hitch item #C86JR is the right hitch for you. The CrossWing weighs in at 87 lbs. The main concern with using the CrossWing on your 2021 Ram 2500 is that…

While not required as it is a 5th wheel hitch, safety chains are always a good idea, including for the Curt CrossWing Lightweight 5th Wheel Trailer Hitch #C86JR. There are even specific chains and mounts for the CrossWing, the Curt Safety-Chain Loops…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

Hey Chris, if the B and W Patriot is the fixed hitch version you could use the rail kit adapter part #C29BR but if it's the slider there isn't a rail kit adapter available and you'd have to go with a new hitch designed to fit the pucks…

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…