Wiring Harnesses Needed For A Gooseneck Equipment Trailer
Question:
Do you carry a pre-made harness to rewire gooseneck equipment trailers? Or, one for the typical rear bumper on them 7 two pin, and 4 three pin? Ive seen them out there, but cant find on your site. Thanks
asked by: Harold
0
Expert Reply:
Hi Harold,
Are you saying that you want to add a 4-pole and/or a 7-way on the back of your gooseneck trailer? Or are you saying you need the wiring for up front to connect to the truck?
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Valcrum Universal Threaded Aluminum Oil Bath or Grease Cap for 6K to 9K Axles - Black
- Trailer Bearings Races Seals Caps
- Caps
- Oil Cap
- Threaded Grease Cap
- 4 Inch O.D.
- Valcrum
more information >
Continue Researching
- Q&A: Is There Kit to Convert 7k Axle from Grease to Oil Bath
- Q&A: Can a Spindle be Replaced on a 7,000 Pound Trailer Axle
- Q&A: Looking For 2-1/2" Long 9/16" Wheel Stud With 0.60"-0.62" Knurl Size
- Q&A: What Is The Knurl Diameter Of The RG03-080 Wheel Stud?
- Q&A: Can a Standard 7K Axle Be Coverted toi Oil Bath Without Changing the Hubs and Drums
- Q&A: Air Bag Kit for a 2019 Chevy Silverado 3500 Cab and Chassis
- Q&A: TST TPMS System TST-507-RV-4 - Can I Swap Cap Sensors For Internal Sensors
- Article: How to Raise Your Travel Trailer Height
Harold
9/4/2024
I’m looking for either a whole trailer replacement harness or even just one for the back of one with the common dot setup (two pin connectors for 2.5” lights on each side, then two more for the outer rear corners, then two three pin for 2x6s, then three two pin for the center three. Jkd products makes some. Resold under several names. PJ trailer part 170291 is an example