What Type of Shank Does Lock N Roll Hitch # 336VS503 Attach to
Question:
Will this also work with the Curt C45901 Adjustable ball mount? Tnx
asked by: Lance R
0
Expert Reply:
Hey Lance, the bolt pattern of the Curt ball mount is different from what the part # 336VS503 is designed to fit so instead you'd need a shank like the part # 336TS505.
expert reply by:
Jameson C
0
Products Referenced in This Question
Lock N Roll 3-Position Adjustable Channel Bracket for 2" Hitch Receivers - 11,000 lbs
- Accessories and Parts
- Adjustable Trailer Coupler
- Channel Bracket
- 11000 lbs
- 3 Mounting Positions
- Lock N Roll
more information >
Product Page this Question was Asked From
Lock N Roll Articulating Hitch - Adjustable Channel Mount - Vehicle Side - 11,000 lbs
- Accessories and Parts
- A-Frame Trailer Coupler
- Adjustable Trailer Coupler
- Straight Tongue Trailer Coupler
- Rotating Coupler
- 11000 lbs
- Lock N Roll
more information >
Continue Researching
- Q&A: Choosing the Correct Rise/Drop for Lock N Roll Articulating Hitch
- Q&A: Comparing Lock N Roll Hitches Drop and Rise
- Q&A: Lock N Roll Hitch Assembly for 5 Inch Drop
- Q&A: Dimensions of the Lock N Roll Articulating Adjustable Hitch
- Q&A: Timbren Axle-Less Suspension System for Off-Road Tear Camper
- Q&A: Max Tire Height and Width for Use with a Timbren Offroad Axle-Less Trailer Suspension System
- Q&A: What is Required to Change the Bolt Pattern on Trailer Hubs
- Article: How to Measure for Trailer Hitch Drop
- Article: My Trailer Hitch Doesn't Fit
- Article: Determining Trailer Tongue Weight
- Article: Trailer Maintenance Schedule
- Article: Trailer Hitch Receiver Sizes
- Article: What Is Flat Towing and How to Ditch the Trailer
- Article: Trailer Lighting Requirements
Lance
9/23/2024
Hello Jameson, Actually I measured my Curt C45901 and the specs match up to the Lock N Roll Vehicle Side Hitch (https://www.etrailer.com/Accessories-and-Parts/Lock-N-Roll/336VS503.html). The Curt C45901's channel brackett is 3" wide (inside to inside), which matches up to the Lock N Roll's specs. The Curt C45901's holes are 5/8" and spaced 1" apart, again matching up with Lock N Roll's 2" apart (skipping one hole of course - in fact, the Curt ball mount holder's spacing is also 2" apart). So based on these specs, it should work. Do you agree? Tnx, Lance