bing tracking image
Q & A Icon

Replacement Reverse Lockout Solenoid for Titan Model 10 Brake Actuating Trailer Coupler

Question:

I need the solenoid that goes with the Tital Surge-O-Matic Model 10 surge brake/trailer coupler. On the solenoid it says: Pressure: 800psi Watts: 8W Volts: 12VDC Orifice: 1/32 I could supply a picture if you wish. If you dont have it I sure would appreciate any advice about where I might find it. Thanks

0

Expert Reply:

I believe you meant Titan Model 10, is that correct?

If so, the Titan # T4748800 Replacement Solenoid Valve you've looked at would be compatible with your coupler. The solenoid would mount between the master cylinder outlet at the rear of your actuating coupler between the outlet and the brake line. The solenoid has two wire leads. One wire would ground to the trailer, the other would connect to the center pin of the trailer connector. Keep in mind, that the center pin of the connector installed on the vehicle will need to be tied in to the reverse light circuit so it gets power when the transmission is shifted into reverse.

The specs you mentioned on your existing solenoid are exactly like the Titan part we offer.

Because of their location, the solenoids are subject to being damaged if somebody steps over the trailer tongue and they aren't careful. A shield is available to protect the solenoid, part # T4836100183.

expert reply by:
0
Mike L

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>