bing tracking image
Q & A Icon

Using the Included Circuit Tester to Install ETBC7 on a 2008 Chrysler Town and Country  


I have part ETBE7 and am trying to use the circuit tester included in the kit, but not having much luck. Do I need to pierce the wires to test them, or just hold then pointed end on them? I connected the clip end to a metal body element, does that need to be clipped on something else? The vehicle i am installing my brake controler on is a 2008 Town and Country. Thanks!


Expert Reply:

You will have to make contact with the copper strands inside the wires using the pointy end of the included circuit tester. Also, make sure the tester is grounded to a clean and corrosion free bare metal surface when testing.

You may find that a different ground location will work better. It is sort of a trial and error process. If you are adding a brake controller and are testing for the correct brake switch wire to attach to the red brake controller wire then on your Chrysler T&C it should be a green wire.

I have included a couple of links to the right that should help.

expert reply by:

Video/Article/FAQ this Question was Asked From

Article or Video