How to Clean 4 Way Connections Points
Question:
How to clean the 4 pole connection?
asked by: Chuck
1
Helpful Expert Reply:
The easiest way would be to get a can of Coca-Cola and pour it on the 4 way and watch as the corrosion disappears.
A little bit of dielectric grease like part # 11755 would help prevent future corrosion if applied to the contact points. I attached an FAQ on dielectric grease for you to check out as well.
expert reply by:
Jameson C
1
Products Referenced in This Question
Dielectric Grease for Electrical Connectors, 2 oz.
- Accessories and Parts
- Trailer Wiring
- Wiring
- Dielectric Grease
- LubriMatic
more information >
Product Page this Question was Asked From
Submersible, Under 80" Trailer Light Kit with 25' Wiring Harness
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Kit
- Surface Mount
- Submersible Lights
- Incandescent Light
- 5L x 4-1/2W Inch
- Red and Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Recommended Replacement Grease Seals and Grease Cap for a Boat Trailer
- Article: Thank you!
- Q&A: Does etrailer Hitch e44AR for 2022 Honda Passport Have Powdercoat Finish
- Q&A: Can 8 Inch Trailer Tires be Replaced with 12 Inch Trailer Tires
- Article: Trailer Tire Sizing
- Q&A: Demco vs. etrailer Hydraulic Dacromet 3,500 lb Trailer Brakes
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Q&A: Replacing Taillights on a 1986 Bayliner 1650 Using Trailer Light Kit TL5RK
- Q&A: What Are the Overall Dimensions of the Optronics Under 80-Inch LED Trailer Light Kit # TLL9RK