bing tracking image

B and W Trailer Hitch - Custom Fit Hitch - BWHDRH25211 Review

content loading

Customers compare BWHDRH25211 to these similar products




Products Featured in this Video



Review of B and W Trailer Hitch BWHDRH25211


Today, were going to review part number bwhtrh25211. This is a BMW Heavy Duty, two-inch class five trailer hitch receiver. This is a custom fit design. For demonstration purposes, I have mounted the end wing brackets to the center cross member. This is a custom fit, so its designed to fit the 2003 to 2008 Dodge 1500 Trucks with the factory bumper, and also the 2003 to 2013 Dodge Ram 2500 and 3500 trucks with the factory bumper. It will also fit any of the Dodge rams that have a factory hitch or without the factory hitch, either way.Basically, the way that would happen is this how these wings will be installed to the cross member.

Just going to rotate these just to show you when you go to mount this cross member to the wings here. They have two sets of holes up here high and low, and then two sets down here. Right now, we put the balls in the top one, so when its in the very top ones that would go on a truck that does not have a factory hitch, so wed bring it up right under the bumper of the truck.If you have a truck that has a factory hitch, it needs to drop a little bit lower. When you install this cross member to the wing plates, you just move it down to that lower set of holes, and that will drop it down a little bit, and position this right under your factory hitch thats on your vehicle right now. Now, this custom fit trailer hitch will let you tow a trailer with your vehicle.

Again, its a bolt on installation. Theres no welding required. Again, its the interlocking three piece design. These two end plates in the center cross member.As these grade eight mounting hardware all included, and the installation instructions are included. The finish is a high-gloss, black powder coat finish to help resist corrosion.

If you notice the safety chain look is right here are built into this heavy duty steel gusset thats welded in. It helps support this hitch receiver.The ball mount, and if youre going to do any towing, you need a ball mount and a pinning clip, and those are not included. They would be sold separately. If you go to the product page for this part number, we do list them as related products. This part is made in the USA.

Again, the receiver opening is two inches by two inches. The rating on this hitch is a class five rating, so the specs would be the maximum gross trailer weight capacity would be 1600 pounds. The maximum gross towing weight capacity when used with weight distribution will also be 1600 pounds. The maximum tong weight used either way as weight carrying or weight distribution would be 1600 pounds. It has a lifetime limited warranty.That should do it for the review of part number bwhtrh25211, the BMW Heavy Duty, two-inch class five trailer hitch receiver. .


Info for this part was:

Employee Joshua S
Video by:
Joshua S
Employee Nicholas E
Test Fit:
Nicholas E
Employee Dustin K
Video Edited:
Dustin K

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.