bing tracking image

Review of Bargman Trailer Lights - Red Incandescent Trailer Clearance Or Side Marker - 30-17-814

content loading

Customers compare 30-17-814 to these similar products




Products Featured in this Video



Bargman Trailer Lights - Red Incandescent Trailer Clearance Or Side Marker - 30-17-814 Review


Hi everybody, Andy here with etrailer.com, and today, we're gonna take a look at this Bargman Incandescent Red Lens Trailer Clearance Light or Side Marker Light with reflector. This rectangle incandescent trailer light serves as a clearance or side marker light when properly installed, and the built-in reflex reflector removes the need for a separate reflector. As you can see, I already have this connected to 12 volt power with the power on, and I'm gonna go ahead and turn the lights off here in my studio, just so you can get a better idea of just how bright this is. This incandescent bulb can be easily replaced, this is a red lens over an incandescent bulb, and this is a P2 rated light, meaning that it produces a 45 degree angle of light to either side of its center line for a total of 90 degrees of coverage. The beam pattern can be seen straight on, but it cannot be seen clearly from the side, so this type of light can be used as either a side marker light or a clearance light, but it cannot be used as both. If you need both functions, then you must install two separate lights on your trailer, one as a front or rear clearance light and one as a side marker light.

Now, this is compatible with 12 volt DC systems, and this is constructed of durable ABS housing, and this is a surface mount to your trailer, and the hardware is not included, so you would have to provide that separately on your own. This is a 2-Wire design, it does not matter which is power and which is ground, they are interchangeable, so you don't have to worry about that. And let me see if I can give you a good measurement here of the wire length, we're sitting right at about 6 1/2 inches long, try and get that to stretch out there, 6 1/2 half inches long on that wire length. This is DOT compliant, and just some overall dimensions, before I do that, just wanna show you how easy it is for that light to pop out, and it's a little bit easier to measure this way as well. Looking at the overall length of this light, we're sitting right at 3 7/8 inches long and about an inch and 7/8 wide, and about 3/4 of an inch thick, and the distance between the mounting holes, center to center, we're sitting right at 3 inches, center to center.

Well, that's gonna conclude our look today, I do hope that it was helpful for you. Again, my name is Andy, thank you for joining me..


Info for this part was:

Employee Cole B
Installed by:
Cole B
Employee Andy C
Installed by:
Andy C

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.