bing tracking image

Review of CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10003G-4

content loading

Customers compare CE10003G-4 to these similar products




Products Featured in this Video



CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10003G-4 Review


Today we're going to take a look at the CE Smith 11-inch long galvanized steel bolster and swivel bracket assemblies for roller bunks, for a quantity of four. Now these bolster and swivel bracket assemblies will let you mount a roller bunk onto your boat trailer.The bracket assemblies are typically mounted upright on your boat trailer's cross members, and they allow a mounted roller bunk which is run from the front of the trailer to the back to pivot while you're loading a boat.The swivel brackets right here on top will let you tilt the roller bunk, and it helps you fit the boat hull snugly onto the trailer during your loading process. You can see it includes the bolt and the locknut for attaching the swivel bracket to the bolster bracket. And the swivel back bracket end is going to bolt to your roller bunk, and the bolster bracket attaches to your trailer frame cross members.You can see it has two long mounting slots on the bracket to allow as much as three and three quarter inches of height adjustment during installation. Basically this bracket installs vertically on your boat trailer's frame with a U-bolt. Now, the U-bolt is not included.

We do sell that separately. But the U-bolt will go through both of those slots. You tighten it down, and again you can adjust it up to three and three quarter inches of height adjustment when you install it.If you notice on this side here, they have a dimpled surface on the bolster bracket. This will help prevent the bracket from sliding among the trailer frame when it's installed. So once you get your U-bolt in there, tighten it down.

Those dimples will help keep it from moving on the frame.It is an 11 gauge galvanized steel. It helps resist rust and corrosion. These brackets are suitable for saltwater exposure. This part includes four bracket assemblies.Give you a few measurements on this .. The overall height from the bottom to the top of the swivel bracket, it'll be right at 11 inches.

The height of just the bolster bracket from the bottom to the top is going to be right at 10 inches tall. And the width on it is going to be right at 2.5 inches wide. The mounting slots we mentioned . there's two of them. The width on those slots are going to be a half inch.

And the length on them is going to be right at 3 and 3/4 inches long.The swivel bracket at the top here . width on that is going to be right at 1 and 3/4 inches by 1 and 1/4 inches. The height of just the swivel bracket from the bottom top is two inches. And the hole here . the mounting hole diameter is 7/16 diameter.But that should do it for the review on the CE Smith 11-inch long galvanized steel bolster and swivel bracket assemblies for roller bunks, for a quantity of four.


Info for this part was:

Employee Jeff D
Video Edited:
Jeff D
Employee Joshua S
Video Edited:
Joshua S

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.