bing tracking image

Review of CUB Blind Spot Detection - RV and Motorhome - CU92XR

content loading

Products Featured in this Video



CUB Blind Spot Detection - RV and Motorhome - CU92XR Review


Hello everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at the Blind Spot Monitoring System for 35 foot long RVs and motorhomes. Now, this is an advanced blind spot monitoring system, which will provide blind spot detection, lane change alert, and even rear cross traffic alert. And as we mentioned, it is for 35 foot long RVs and motorhomes. This kit will include everything shown here on the table. Just wanna zoom in, give you a better look at the pieces here, and we'll go through them all.

I'm gonna start with the left and right blind spot radar sensors with the gaskets, the control unit, right here it includes the left and right pillar mount warning indicators, a power button, a buzzer, it includes the wiring harnesses you need, even includes an OBD-II harness, it includes the hardware, the connectors, and they even have include a hole drill bit for installation of the indicators. Also has a nice installation guide and operation guide that'll show you how this operates and how it installs. Now, this system will monitor blind spots for increased safety while driving your RV or motorhome. We mentioned it is compatible with most 35 foot long RVs and motorhome, does include a 35 foot long trailer harness. Now, this will work in areas with low reception, such as tunnels or mountains.

We mentioned the sensors here, these are a left and a right radar sensor, they are equipped for blind spot detection, lane change alert, and rear cross traffic alert. These are designed to mount at the rear corners of your RV or motorhome. They do work on a radar frequency of 24 gigahertz. Now, the blind spot detection will monitor adjacent lanes for up to 75 feet, and they'll automatically activate when your vehicle exceeds 15 miles per hour. The lane change alert will monitor adjacent lanes and indicate when vehicles are within the warning zone, and they'll activate with the use of turn signals, again, when the vehicle's exceeding 15 miles per hour.

They'll even detect vehicles approaching at high speeds within two seconds of potential impact. And then the rear cross traffic alert, this will monitor for obstacles up to 60 feet behind your vehicle, and they will activate when the vehicle is placed in the reverse. We mentioned these indicators, they are a left and right LED indicator, and they are a pillar mount design, so they do provide audio and visual alerts, and it'll alert you to the side of the warning by blinking and admitting an audible tone. Now, to install this, it is a very simple installation, comes with all the included connectors, all the wiring and harnesses you need, even comes with this OBD-II connector that'll plug into your OBD-II system, works with that diagnostic system to ensure accurate readings, and everything is an automotive grade wiring harness and uses weather tight connectors. Also, this system is ISO 17387 Type 3 blind spot detection system standard compliant.

But that should do it for the review on this Blind Spot Monitoring System for 35 foot long RVs and motorhomes..


Info for this part was:

Employee Jeff D
Installed by:
Jeff D

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.