bing tracking image

Dexter Axle Trailer Hubs and Drums - Hub - 8-213-5UC1 Review

content loading

Customers compare 8-213-5UC1 to these similar products




Products Featured in this Video



Review of Dexter Axle Trailer Hubs and Drums 8-213-5UC1


Speaker 1: Today we're gonna take at look at the Dexter Trailer Idler Hub assembly for 5,200 pound and 6,000 pound axles, with the six on five and a half inch bolt pattern. This hub assembly will fit trailer idler axle. Comes with everything shown here on the table. Comes with the hub assembly itself, both the inner and outer bearings. The bearing races are includes, they are pre-installed in the hub assembly already. The grease seal, the grease cap, and the wheel lug nuts are all included.This assembly is a sturdy iron construction.

It is made in the USA. The application is for 5,200 pounds to 6,000 pound trailer axles. The wheel size that'll fit on this is 16 inches and larger. The hub flange diameter, which is measured from this end to this end is seven and a half inches. Bolt pattern again is six on five and a half inches.

The wheel stud diameter is half inch, and the weight capacity on this one assembly is 3,000 pounds, so when this is used with one on the other side of the axle, it'll meet the 6,000 pound axle capacity.Now, the bearings that are included. The inner bearing, the larger one is part number 2558O, has a 1.75 inner diameter. That'll go onto the inner bearing race just like that. The outer bearing, which is a smaller one. It's part number LM67048, has a 1.25 inner diameter.

That'll go on the outer bearing race just like that. Bearing race as we mentioned are all pre-installed.The seal it comes with is a Double Lip Grease Seal, part number 10-10, has an inner diameter of 2.125 inches, and an outer diameter of 3.376 inches. That'll go in the back after your bearing's installed and you've pressed your seal in just like that. And then on the outside it comes with the grease cap, part number F001520. Has a flange diameter of 2.44 inches, and after your outer bearing is installed in there, then you put your cap on just like that.It does come with six of the half inch by 20 sized lug nuts, part number X1023R.

That should do it for the review on the Dexter Trailer Idler Hub assembly for 5,200 pounds and 6,000 pound axles, with the six on five and a half inch bolt pattern.


Info for this part was:

Employee Patrick B
Installed by:
Patrick B
Employee Jeff D
Installed by:
Jeff D
Employee Jacob T
Video by:
Jacob T
Employee Conner L
Test Fit:
Conner L

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.