bing tracking image

Review of Dexter Axle Trailer Hubs and Drums - Hub with Integrated Rotor - K08-435-05

content loading

Customers compare K08-435-05 to these similar products




Products Featured in this Video



Dexter Axle Trailer Hubs and Drums - Hub with Integrated Rotor - K08-435-05 Review


Jeff: Hello everybody. This is [email protected] Today, we're going to take a look at this Dexter 10 inch hub and rotor assembly with the five on four and a half inch bolt pattern with a 3,700 pound weight capacity. Now this hub and rotor assembly will work with the 3,500 pound and 3,700 pound Dexter disc brakes. Does use a machine process which will minimize run out and warping. And since it's an all hub and rotor is all one piece, there's no chance for any contaminants that can get in between the rotor and the hub.

You can see it's a vented design, which will regulate the temperature to prevent overheating. It's a cast iron construction to provide strength and durability, and then they use a zinc finish over the whole assembly to protect against corrosion and wear. This part is made in the USA. It is designed to fit axle capacities of 3,500 pounds and 3,700 pounds.The wheel size that'll fit on this is fourteen inches and larger. Bolt pattern is five on four and a half inches.

The wheel bolt diameter is a half an inch and the actual rotor diameter it's classified as a 10 inch, but if you actually measure it, it's just under, it's about nine and three quarter inches.Now the bearings, the grease seal, the grease cap and the lug nuts are not included. Those are all sold separately on our website.The bearings, now the bearing races are included. They are pre-installed in here. The bearing race at the bearing rides in the outer bearing races right in there. And there's your inner bearing race.The bearings that they use for the inner bearings part number L six eight one four nine outer bearing part number is L four four six four nine.

And the grease seal that's installed in the back here, that is part number RG zero six dash zero five zero, but that should do it for the review on the Dexter 10 inch hub and rotor assembly with the five on four and a half inch bolt pattern and a 3,700 pound weight capacity.


Info for this part was:

Employee Jeff D
Installed by:
Jeff D

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.