bing tracking image

Dexter Axle Trailer Hubs and Drums - Hub with Integrated Drum - 8-219-4UC3 Review

content loading

Customers compare 8-219-4UC3 to these similar products




Products Featured in this Video



Review of Dexter Trailer Hubs and Drums 8-219-4UC3


Today were going to review part number 8-219-4UC3. This is the Dexter Trailer Hub and Drum Assembly with an 8 on 6-1/2-inch bolt pattern for 1/2-inch studs. This trailer Hub and Drum Assembly will include your eight 1/2-inch cone seat lug nuts. It will include the inner bearing, part number 25580, it will include the outer bearing part number 14125A, it will include the grease seal which is a 2-1/8 inch diameter grease seal, and will also include the grease cap which goes over the hub right there. Now the bearing races are included also. They are already installed, pressed into the hub.

There is the outer, and when I spin this around youll be able to see the inner race right there. The application on this Hub and Drum Assembly will fit the 5200 to 7000-lb Dexter axles. It has a drum dimension of 12 inches by 2 inches wide. The stud diameter for the wheel studs is 1/2 inch. The bolt pattern is an 8 lug 6-1/2 inch pattern.

Now the capacity on this Hub and Drum assembly is 3500 lbs. So when this one is used with another Hub and Drum Assembly on the other side of the axle it will give you the max of 7000 lbs. I do want to give you a few dimensions. The bolt pattern which we mentioned is 8 lugs 6-1/2 inch. So basically the way you would measure that is on a Hub and Drum that has an even amount of lugs which in this case would be eight, you just take one or pick any of the studs and measure from the center of that to the one directly across from that.

So if you go from center to center it will be 6-1/2 inches and that will give you the 8 lug 6-1/2 inch bolt pattern. The other dimension I would want to give to you is the drum size. It is 12 inches. Thats the measurement of the inner of the drum. And then the width will be 2 inches.

So this Hub and Drum assembly will work with 12-inch by 2-inch brake assemblies. And that should do it for our review on part number 8-8-219-4UC3.


Info for this part was:

Employee Jeff D
Installed by:
Jeff D
Employee Kevin C
Installed by:
Kevin C
Employee Thomas T
Video by:
Thomas T

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.