bing tracking image

Draw-Tite RV and Camper Hitch - Frame Mount Hitch - 5350 Review

content loading

Customers compare 5350 to these similar products




Products Featured in this Video



Review of Draw-Tite RV and Camper Hitch 5350


Speaker 1: Today we're taking a look at the Draw-Tite Multi-fit Motorhome Trailer Hitch. The multi-fit motorhome trailer hitch fits most motorhomes and RVs with chassis from 24 inches to 46 inches wide. This hitch has a two-inch by two-inch opening and will accept standard two-inch hitch accessories, so your accessory, or ball mount, slides into the receiver tube. You line up the pinholes and secure it with a hitch pin and clip, hitch lock, or the J-pin stabilization device. All of those items are sold separately and available at etrailer.com. The pinhole for securing an item inside the receiver will accept a standard five-eighth inch diameter pin or hitch lock.Now, the unit is made from a durable steel construction.

It has a really nice black powder-coated finish on it to resist rust and corrosion. It's a simple three-piece construction, so you have your hitch, that's welded onto the main tube. You have a bracket on this side, and you have a bracket on this side, which I did not install, because I want you to see what the bracket is with it off of the actual hitch. It's a nice design. You take it, slides on, and you can adjust it.

Now, this is able to fit frame widths, again, anywhere from 24 inches to 46 inches wide. The bracket simply just slides along the main tube. That way, you can easy place it in a spot that works best for your application.Mounting hardware is included. It's a bolt on installation, no welding required. Receiver opening measures two inches by two inches.

Now, the capacity sticker is located right here. On that sticker is says that the maximum gross trailer weight capacity is 5,000 pounds weight carrying and 6,000 pounds with weight distribution. Maximum tongue weight is 500 pounds weight carrying, 750 pounds with weight distribution. The brackets, right here, edge to edge is 10 inches long, side to side is two inches wide. Mount holes are separated, on center, by eight and five-eighths inches.

From top to bottom measures about five and a half inches. Also, Draw-Tite covers this product with a limited lifetime warranty. Last thing I want to mention, real quick, is just a simple measurement from the center of the tube to the front of the receiver. That gives a measurement of about seven inches.That's going to do it for today's look at the Draw-Tite Multi-fit Motorhome Trailer Hitch.


Rick D.

3/10/2021

Thanks much. Very helpful. May I rotate the movable plates 90 degrees? Thanks,

Etrailer Expert

Jon G.

3/11/2021

You could probably get them to install that way but that's not how this hitch was designed to be installed. If you rotated the mounting brackets 90 degrees then it would likely alter the weight rating of the hitch.

Info for this part was:

Employee Cole B
Installed by:
Cole B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.