bing tracking image

Hopkins Custom Fit Vehicle Wiring - Trailer Hitch Wiring - N40975 Review

content loading

Customers compare N40975 to these similar products




Products Featured in this Video



Review of Hopkins Custom Fit Vehicle Wiring N40975


Today we're going to review Part Number N40975. This is the Hopkins factory style seven-way and four-way flat vehicle and trailer connector with the included relays. This is a custom fit part number. It is designed to fit the Nissan Armada and Nissan Titan starting in 2004 and they are for vehicles that do not have the trailer connector on them. Basically right here this will plug into the vehicle's factor plug, which is usually located behind the bumper of the vehicle. This will provide a seven-way and a four-way trailer connector hookup. It also includes the mounting bracket for this plug and a couple of screws to install the mounting bracket to your vehicle.

Also you'll notice it comes with the three relays that are required to activate the wiring harness. On some 2004 and 2005 Nissan Titan models they might only require two of the relays, but most of them will require all three. Basically the large brown relay is made to activate the 12-volt power circuit and these two smaller blue relays will activate your brake and turn signals. Basically when you go to these relays to install, you go to actually your relay panel, which is usually on the passenger side under the hood right near your battery. Remove the cover that's on the relay panel and then basically if you look on the panel, it will usually have a map of what each location is. You just find the trailer turn right hand and trailer turn left hand for the blue relays. Then you also look for the brown relay ...

You'll find a position that will say trailer tow number two and you'll insert this into it. On the factory plug here, the seven and four-way, you'll notice it does come with this mounting bracket. What's nice about this is you have your screws to install this to the vehicle and then there's clips right on here. Once you get this plugged in, you just push this in the mounting bracket. It'll click right into place and you're ready to go. If you need to remove it, just push in on those clips and it'll pop it right out.

Very easy to install. That should do it for the review on Part Number N40975, the Hopkins factory style seven-way and four-way flat vehicle and trailer connector with the included relays. .


Info for this part was:

Employee Joshua S
Video Edited:
Joshua S
Employee Jacob T
Video Edited:
Jacob T
Employee Nicholas E
Test Fit:
Nicholas E
Employee Brent H
Test Fit:
Brent H
Employee David F
Test Fit:
David F
Employee Kathleen M
Video by:
Kathleen M
Employee Hayden R
Video by:
Hayden R

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.