In-Depth Review of the Kodiak Hydraulic Brake Line Kit Video

Usually when we see leaking on a brass fitting like the tee from the Kodiak Hydraulic Brake Line Kit #18SI-BLKIT it is due to overtightening. Start by hand tightening, then take it around 2-3 rotations with a wrench. After that check for leaks and…

For a disc brake model with an electric reverse lockout solenoid you can use #099-175-20. This would be a great replacement solution for the model 70 you have on your trailer.

I can help you find the correct sized keel rollers that you need. Most Keel Rollers fit either a 5/8 inch shaft or a 1/2 inch diameter shaft. You want to know the diameter of the shaft that the rollers fit on. The easiest way to figure out the length…

The 12 inch measurement for the product description has to do with the size bracket that it will fit. If you only have 1/2 an inch of a gap between the Yates Keel Roller #YR12244-125EC and your bracket you will be fine. It is okay for there to be…

Since you have a Yates roller 12244 currently the correct replacement would be the part #YR12244-125EC that you referenced. Then for a replacement shaft with pal nuts you'd want the part #CE10727A and you'd be set.

I have another option for you, but we do not currently carry any Keel Rollers that would fit a 1-5/16" pipe. Instead I recommend going with the Yates Keel Roller for Boat Trailers - Super-Heavy-Duty Rubber - 12" Long - 5/8" Shaft…

According to Yates Rubber, the #YR12244-125EC roller technically carries a 400 lb capacity, but the roller shaft like #CE10727A and the mounting bracket like #CE10305G do most of the heavy lifting. This is the strongest keel roller they offer. My…

No, the Caliper Rebuild Kit for 6,000-lb to 8,000-lb Dexter Disc Brakes #K71-670-00 will not work with your Kodiak 225 Calipers, you'd need to use the Kodiak Disc Brake Caliper Rebuild Kit for 3,500 lb to 6,000 lb Trailer Brakes #KDBC225KIT…

There is a replacement that I recommend for the Tie Down 70E disc brake actuator, though you will want to verify that your mounting bolt holes are 3 inches apart on center and your tongue is a 3 inch channel. If they are I recommend the Dexter DX7.5…

For a disc brake model with an electric reverse lockout solenoid you can use #099-175-20.

I believe we can narrow this down based on the information you are referencing. However, the best way to be sure is to measure your existing bearings or spindle with a digital caliper like the #PTW80157. It looks like one bearing is stamped with…

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…