bing tracking image

Kodiak Trailer Hubs and Drums - Hub with Integrated Rotor - KHR10D Review

content loading

Customers compare KHR10D to these similar products




Products Featured in this Video



Review of Kodiak Trailer Hubs and Drums KHR10D


Today we're going to review part number KHR10D. This is the Kodiak 10" Disc Brake Integral Hub-and-Rotor, with the 5 on 4 1/2" bolt pattern. Has a Dacromet finish and it fits 3500 pound axles. This single piece assembly will make installation a snap. Whether you're retrofitting your brakes, or switching from drum brakes. It has a nice machined finish. Which will minimize runout and warping.

It is balanced to help provide a smooth ride. If you notice, the rotor itself has a vented design to it. This will help dissipate the heat and prevent any heat related damage. It does have the half inch wheel studs already installed in it. Also, it has the installed industry standard bearing races.

For the outer bearing right here, and the inner bearing right here. They are already installed into the hub and rotor. It is a cast iron construction, which gives a nice friction coefficient, for necessary stopping power. The Dacromet finish is to provide a superior corrosion resistance for fresh water, or salt water use. That Dacromet finish has a 400 to 600 hour salt spray rating, when it's tested. This is designed to fit the 3500 pound axles.

It is designed to use wheel sizes that are 13" and larger. Again, the bolt pattern is a 5 on 4 1/2" bolt pattern. It does use the wheel lug size of a 1/2" by 20. The outer diameter on this rotor, I just want to give you that measurement, from edge to edge, it's going to be right at 10". Also on the product page, the part number, the product page for this part number at the very bottom of the page, it will also list the required part numbers for the bearings and the grease seal that will fit this hub and rotor. That should do it for the review on part number KHR10D. The Kodiak 10" Disc Brake Integral Hub and Rotor with the 5 on 4 1/2" bolt pattern and the Dacromet finish.

.


Info for this part was:

Employee Jeff D
Installed by:
Jeff D

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.