bing tracking image

Review of Kuat Hitch Adapters - Hitch Reducer - KU93VR

content loading

Customers compare KU93VR to these similar products

Products Featured in this Video

Kuat Hitch Adapters - Hitch Reducer - KU93VR Review

Hello everybody, this is Jeff at Today we're gonna take a look at this Kuat 2 and a half inch to 2-inch Hitch Receiver Reducer Sleeve. Comes in two pieces. Now this hitch reducer sleeve will let you use your 2-inch hitch bike rack with your 2 and a half inch by 2 and a half inch hitch receiver. Basically these two pieces will slide into the trailer hitch receiver, and it reduces the size from that 2 and a half inch by 2 and a half inch down to the 2-inch by 2-inch. If you notice, each piece has an elongated section that's open here and this is designed to work with the hitch pin that'll go through and it works with Kuat's hand tightening cam system.

Now these pieces do have a magnet on 'em that allow the pieces to be held in place once positioned correctly in the hitch receiver. You can see how the magnets work and I'm gonna demonstrate. I happen to pull a 2 and a half inch by 2 and a half inch opening here, just to show you what it's, how it works. Basically, you know if you also, if you notice they have a raised tab on the front end here that keeps it from pushing all the way into there. So you'll take this one.

And as we mentioned, here's your hitch pin hole. So you wanna match it up where this cutout is where your hitch pin hole is. So this one will put up at the top and you notice the magnet holds it in place, keeps it open. This part here has the cutout. So we wanna line it up with the hitch pin hole, slide it in on this way.

And again, push all the way in. You can see the tabs will keep it where it should be. And then if you notice, the hole still goes all the way through. Now, this is a, these pieces are sturdy steel construction. They have a nice black powder coat finish on 'em which is rust resistant.

And again, the application fits 2 and a half inch by 2 and a half inch hitch receivers. And then you can see, it cuts it down to the 2-inch by 2-inch size. Last thing I wanna do is just give you the overall length on these pieces. So if we go from one end to the other, you can see it's right at 6 and a quarter inches total length. But that should do it for the review on the Kuat 2 and a half inch to 2-inch Hitch Receiver Reducer Sleeve..

Info for this part was:

Employee Andrew K
Installed by:
Andrew K
Employee Jeff D
Installed by:
Jeff D
Employee Jacob T
Video Edited:
Jacob T
Employee Jonathan Y
Video by:
Jonathan Y

At we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.