bing tracking image

Lippert Components RV and Camper Steps LC301695 Review

content loading

Customers compare LC301695 to these similar products




Products Featured in this Video



Review of Lippert Components Accessories and Parts LC301695


Today, we're going to be taking a look at the replacement motor for an electric coach step. This replaces the 12 volt motor that came standard on your single, double, or triple electric Lippert coach step or Stromberg Carlson sliding step. This unit's designed to power the gear assembly that allows the step to extend and retract. It draws power directly from the RV battery which is going to allow it to bypass the electrical system. It simply installs underneath the base of your step with three bolts. Here's the mounting location for those bolts.

Those bolts are not included. The motor in the gear box assembly can be replaced by disconnecting the two pin connector from the module to the motor and then you'll need to remove the p clamp. That's going to be holding the harness to the motor mount. You'll also need to remove the ball joint linkage from the gear and remove a self tapping screw that holds the ground wire in place. Then you'll need to remove the three bolts that hold the motor mount to the step base. I do want to mention that care should be taken not to disturb the adjustment in the length of the ball joint linkage.

Then you simply install the new motor in reverse order. Really simple process. Only takes a few minutes to do. I do need to mention that you need to know that no adjustment is required. You will notice that this is a weather proof plug. It's got the snap lock designs once it's connected, snap lock together, and then it's got the jacketing that goes over the wires.

It's going to keep those safe and protected. That's going to do it for today's look at the replacement motor for an electric coach step. Again, this replaces the 12 volt motor that came standard on your single, double or triple electric Lippert coach step or Stromberg Carlson sliding step.


Questions and Comments about this Video


Wayne R.
Need location of six spacers and where flat metal shim with bolt hole goes.
Etrailer Expert
Reply from Chris R.

Check out the answer page I linked below. It shows a couple of really nice diagrams of the spacer (part # LC128958 ) and where they're located.

Info for this part was:

Employee Cole B
Installed by:
Cole B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.