Replacement Drive Head Pin for Solera Power RV Awnings: The Breakdown Video

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

Not quite, there is an additional screw below the wax screw in the end cap that also must be removed on the Solera Power Awning Idler Head #LC672052. From here you can remove the roll tube from the drive head. After the drive head is removed, there…

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

Based on the pictures you definitely need the awning support arm #LC281154. I can't tell in that other photo if the pin is bent or damaged, or just barely hanging in there. I'm also not sure if your idler head and roller endcap are ok or not…

Since you were looking at the Regal style idler head #LC672052 I'm assuming you need to replace the idler head pin on your Solera awning. You can remove the old pin and install #LC27WD for a replacement. If by key you mean a cotter pin, then yes…

We do carry the Dometic RV Water Heater #DMC74FR which you could use to replace your Atwood G6A-8E 6 gal RV Water Heater, but I highly recommend switching over to a tankless system like the Furrion RV Tankless Water Heater 60,000 BTU #FR98SR. This…

We have the exact parts you need for your 2021 Palimino Puma. You are looking for the following: 3 x Replacement Retaining Washers for Solera Pitch Arm Assembly #LC431583 1 x Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support…

I reached out to Lippert and they confirmed that you will need the Replacement Head Pin #LC93FR for Solera Power Awning Gear Drive Head #LC273478.

The Regal Drive Head #LC53TF is a little skinnier and doesn't have a logo while the Plain Drive Head #LC273478 is a little wider and has the LCI logo on it (see attached).

The replacement pin you need is the part #LC93FR.

The Solera awnings do not use a spring that applies tension on it so that won't be a concern. What you will want to do when installing the Solera Power Awning Replacement Motor #LC266149 is to bring the awning out about 12 inches or so and then…

The white color version of the Replacement Short Arm Assembly for RV Awnings - 63" Long - Black #LC404523 is available with part #LC97UD.