bing tracking image

Review of MORryde RV TV Mount - Sliding Around the Corner Wall Mount - MR72ZR

content loading

Customers compare MR72ZR to these similar products




Products Featured in this Video



MORryde RV TV Mount - Sliding Around the Corner Wall Mount - MR72ZR Review


Hey everybody, I'm Ellen here at etrailer.com. We're taking a quick look at the MORryde TV wall mount. This is going to help to move your TV out wherever you need it to be, so it does slide along horizontally. I have this laid out flat on my table, but normally it'd be mounted on the wall like so. If you have an area where there's just not really a good spot for the TV to live on an actual wall, you could mount this in one spot and then slide the TV over so that you can actually see what's going on, and be able to have that at a good angle for you. Basically what's gonna happen is you could adjust this along the track.

There's just gonna be this piece that unlocks here, and that'll allow this to open up. It's kinda awkward to do without it being actually mounted. But once that's released, it's gonna slide along on two different tracks. You'll have one big one and then the smaller track. Once that goes all the way over to the side, you can actually rotate that around a corner as well.

If you pull the pin, it allows you to adjust the angle to a 45-degree, and then all the way to 90 degrees. It really makes for a very flexible mounting situation in your RV, in your camper, to make sure that you can always see the screen no matter where you might need to mount this. Then once you're traveling, locks that into place so it can't move. It's not gonna be sliding all around the place while you're going around corners or anything like that. It does have a pretty universal plate here.

This has all kinds of pre-drilled holes to match up with any of your VESA mounting plates. The back of TVs all have some version or some pattern that's gonna be included in this. It also comes with a bunch of different hardware to make it easy to mount up this piece and also to mount your TV to the bracket itself. It makes for a really nice way to keep that TV in a good spot so your whole family can see it. As far as the measurements with this, those are listed out on our website.

The fully-retracted would be like you see it here. Fully extended would be like I had it all the way out to the side. The mounting plate measures about 8 7/8 by about 10 1/8. The swivel can rotate about 120 degrees, and this can handle up to 50 pounds for the load capacity. That's pretty much all there is to it for our look at the MORryde adjustable, horizontal-sliding TV wall mount. I hope this has been helpful in deciding if this is the right mount for you. We do have a lot of other RV accessories here at etrailer.com, so be sure to check them out, and thanks for watching..


Info for this part was:

Employee Kathleen M
Installed by:
Kathleen M

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.