Customers compare STL69RB to these similar products
Products Featured in this Video
Today we're going to review part number STL69RB. This is the Optronics sealed thin line LED trailer stop, turn, and taillight for over-80"-wide trailers. Now this is a red rectangular trailer light, serves three functions for trailers that are more than 80" wide. It's the stop, turn, and taillight functions. This is a great replacement for incandescent lights because there's no bulbs to have to be… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
I'll compare some of the most different aspects of these 3 lights you referred to: The Thinline LED Trailer Tail Light - Stop, Tail, Turn #STL59RB has a clear lens with red LEDs. It is submergible and measures 12-5/8 long x 1 tall x 1/2 inch…
view full answer...Lighting requirements for trailers over 80-inches wide do vary a bit depending on the trailer's gross weight. The linked article details the National Highway and Traffic Safety Administration (NHTSA) guidelines for trailer lighting based on…
view full answer...For a similar style light to the glo brite you mentioned, I recommend using the Thinline LED Trailer Tail Light w/Reflector #STL69RRXB which has tail, turn and brake light functions. This light is 15" long and 1-5/8" wide; the mounting…
view full answer...The orange wire you found is the CHMSL circuit. This is the center high mount stop light wire. It is not used by a brake controller so you can tape it up and stow it out of the way. The wires that you will need with be 12 volt power, output to…
view full answer...Your older model Yakima Viper Bike Rack (par 8002000) can definitely be mounted to your 2009 Subaru Outback Wagon. We need to go with your option 1 though as the Viper isn't compatible with the Mighty Mounts. A complete Yakima Round Bar Roof Rack…
view full answer...We don't carry lights with those colors, so you will need to test them based on function. Normally black and red are power and white is ground like you see in the #STL69RB. I would try the yellow as ground. Red is most likely the turn signal and…
view full answer...I pulled the Optronics LED Trailer Light Kit, part #TLL16RK, from our warehouse and measured the outside dimension. I shot a little video as I measured the lights for you to check out. The outside dimensions of the lights measure approximately 8…
view full answer...Yes, we do have the complete kit with all the wires and lighting you will need to rewire and set your trailer up with new lights. We have two options depending on the amount of side marker lights you want. The first is the LED Combination Trailer…
view full answer...The only difference between the two is the height of the lamp. The Optronics #STL69RRXB is 15 inches long by 1-5/8 inches tall, while the #STL69RB is 15 inches long by 1-3/8 inches tall, a 1/4 inch difference. Other than that, both lamps are pretty…
view full answer...It sounds as if there is a weak ground connection somewhere on the trailer. Ground issues normally show up when there is more load on a system. Your situation is a perfect example of that. With the running lights on already drawing power, stepping on…
view full answer...Since I do not know what tow vehicle or wiring harness you have I will try to give you the best general guidance I can. Usually the best way to troubleshoot your wiring issue is to disconnect the trailer from the truck's 4-pole and test each one…
view full answer...You can use a strap type winch instead of a cable winch so long as your trailer's rollers are in good shape and the weight of your 28-ft Cuddy is not more than 3-times the winch's rating. Rollers allow you to use a winch rated for as low as…
view full answer...