bing tracking image

Tekonsha Custom Fit Vehicle Wiring - Trailer Hitch Wiring - TK22113 Review

content loading

Customers compare TK22113 to these similar products




Products Featured in this Video



Review of Tekonsha Custom Fit Vehicle Wiring TK22113


Today we're going to take a look at the Tekonsha OEM Replacement Vehicle Wiring Harness with the Brake Controller Adapter and the 7 Way Trailer Connector. Now, this is a custom fit part, it is designed to fit the 2014 to 2015 Dodge Durango and on any custom fit part I always like to recommend to go to our website. Use our fit guide, put in your year and model of vehicle and that'll show you if this will work for your application. Now, this complete wiring harness will replace a damaged 7-way RV trailer connector on your vehicle. The towing prep kit here, everything included, replaces the damaged factory 7 way trailer connector at the back of your vehicle. It will enable your truck to power your trailer signal lights. The T-One connector right here, one for each side, they just plug in to connection point that are located behind the tail light.

You unplug the harness from the tail lights, plug this in on both sides. The green is for the passenger side, the one with the yellow wire in it is for the driver's side. Then you'll run the body harness up to the car's battery. Connect it with these wires here to the battery using these fuses, in line fuse holders. The other end of this will connect to the 7 way to supply power to that 7 way.

Now, it does include this ModuLite tail light converter, and that's so I'm sure that your vehicles wiring will match that of your trailer. It also reduces the strain on the wiring system. Now, the wiring adapter right here, this is for the break controller. That's so ease installation of your electric brake controller. A custom connector will plug in to the built-in port right here.

That's underneath the dash of your vehicle, the other end will plug into the back of your electric brake controller. Now, this is compatible with the Draw-Tite and Tekonsha time-delayed brake controllers, and the Tekonsha proportional brake controllers. If you go to the product page for this part number, they're list the different part numbers that this will work on. Few specs on this harness, the maximum amperage for the stop and turn light circuits are just 4.2 amps per circuit. For the tail light, it's 7.5 amps total. It comes with everything showing here, it even has a nice set of detailed instructions with pictures of your connections, and describes how to install it. Just simply, we had mention how to install a brake controller adapter, but basically what you will do is the green wire key connector again would plug in behind the passenger side tail lights.

It has a white wire that you want to connect to a good clean ground. The T-Connector with the yellow wire in it is for the driver's side, you'll plug in behind the tail lights. There's two blue wires, an 18 gauge and a 12 gauge. There will connect to the body harness of the vehicle. Then again, this will run all the way up through the in line fuse holders to the battery connection points. The other end of these wires, they're all taped together now, they would connect to this connector and plug in to the 7 way. That should do it for the review of the Tekonsha OEM Replacement Vehicle Wiring Harness with the Brake Controller Adapter and the 7 Way Trailer Connector.


Questions and Comments about this Video

Info for this part was:

Employee Jeff D
Installed by:
Jeff D
Employee David F
Installed by:
David F
Employee Dustin K
Video by:
Dustin K
Employee Chris R
Video Edited:
Chris R

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.