Ultimate Overview of the #84 Spindle for 3,500-lb Trailer Axles Video

For a high quality trailer and wheel that has an ST175/80R13 mounted to it is the part #AM31998 which has a Load Range D and an aluminum wheel. It has an automotive tread pattern and a higher speed rating at 81 mph. Our trailer wheel and tires that…

The Kodiak disc brake kit you are wanting part #K2HR35D can be used on your axle but you will just need to go with a different seal instead, part #168255TB. This has the same outer diameter as what the hubs fit but instead has the correct inner…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

I can see in your attached picture that your tire size is ST205/75-14 which is a very common size and would mean that you would need a 14 inch trailer wheel with a 5 on 4-1/2 inch bolt pattern like the Aluminum Liger Wheel part #LH84FR or any of the…

The hub you have is the Dexter Trailer Hub and Drum Assembly #84557UC3, which is for 3,500 lb axles. The closest option we have to the measurements you mentioned is a 3,500 lb axle that is 74 inches from spring center to spring center, 82-5/8 inches…

There is an option very, very similar to the #84 Spindle for 3,500 lb Trailer Axles - 2" Diameter #TRU24FR that includes a brake mounting flange, though not exactly the same. The difference is in the stub dimensions, as the aforementioned has a…

We offer 3 spindles that have the dimensions compatible with the Dexter Trailer Hub Assembly, part #84545UC1-EZ. The first is part #TRU74FR. This is a 1.75 inch round EZ-Lube spindle with a grease fitting and a brake flange. This spindle has an…

That is a good question but the Trailer Idler Hub Assembly for 3,500-lb Axles #AKIHUB-545-35-K can absolutely be used on your axle rated for less than 3,000 lbs. What matters is that you have the same #L68149 inner bearing, #L44649 outer bearing and…

It is highly recommended that the spring seat be at minimum tack welded to the axle. There have been issues that have resulted from the seat not be welded to the axle. If you do not have access to a welder, I recommend taking the trailer to a local…

Square axles can be tough to determine capacity. Often times the same spindle fits a range of axle capacities. The best way to determine the capacity is to get the inner and outer bearing numbers stamped into the metal of the bearings like you did.…

Square axles normally don't have spring seats like a round axle but do have a hole for the leaf spring bolt to fit into. Take a look at the CE SMITH #CE33201GA-HUB for a visual. The U-bolt mounting kits will have a hole in the center for the…

It sounds like you have the 4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles #e54SR which are 25-1/8". This measurement is taken with the leaf spring relaxed from center of bolt hole to center of bolt hole. With them holding the weight of the…