bing tracking image

CIPA UTV Adjustable Right Hand Side Mirror Installation - 2014 Polaris Ranger

content loading

Customers compare CMM38 to these similar products




Products Featured in this Video



How to Install the CIPA UTV Adjustable Right Hand Side Mirror on a 2014 Polaris Ranger


All right, today on this 2014 Polaris Ranger Crew 570 we're going to install part number CMM38 from CIPA. This is the CIPA UTV Adjustable Side Mirror for the right-hand side. We'll go ahead and layout the parts first. We have the mirror assembly and then the machined mount that the mirror threads into and then the clamp. Now, we have the clamp and machined mount already put together to show you how the hardware works together where 0:26 the machine mount, a lock washer, then the clamp, then another lock washer, and then the nut. Now, inside the clamp will be a rubber strip as well.

Now, we'll start of by disassembling the clamp from the machine mount and we'll go ahead and fit it around our roll cage on our UTV. We'll go ahead and spread it out and slip it over make sure we have it wide enough, then we'll take it out and then we'll go ahead and reinstall this time with the rubber strip. We'll go ahead and push it back together and then loosely install the machined mount. In this case, the holes didn't lined up pushing it back together, so we use an alignment tool to help bring them back together. This also could be a small screwdriver. We'll go ahead and install the machined mount with the lock washer on one side and then through the clamp and then the lock washer and nut.

We'll loosely install them and we'll go ahead and take up of the slack so that it doesn't move around. Then we'll install the mirror into the machined mount. We'll start a few threads in inaudible 1:19 secure and then, we'll alternate back and forth tightening them down to make sure the mirror stays in position that we want. Now, when we thread the mirror into the machined mount, we'll go ahead and run the threads all the way down till they stop. You definitely do not want to over tighten here.

Then we'll go ahead maneuver the clamp to it's final position then tied it down for good. All for a few minutes our mirror is already installed and ready to go. Let's go ahead and take it for a test ride. That will finish it for part number CMM38 from CIPA on our 2014 Polaris Ranger Crew 570. .


Info for this part was:

Employee Joe V
Test Fit:
Joe V
Employee Jeff D
Installed by:
Jeff D
Employee Andrew L
Video by:
Andrew L
Employee Sue W
Video Edited:
Sue W

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.